Home page Home page Home & Household Supplies Home electrical supplies Back boxes and blanking plates Wire Branch Quick Connectors 30 pcs Lever Connector 1 Input and 4 Outputs for Conductor Cross-Sections 0.08 to 2.5 mm² 32 A 250 V Copper
Wire Branch Quick Connectors 30 pcs Lever Connector 1 Input and 4 Outputs for Conductor Cross-Sections 0.08 to 2.5 mm² 32 A 250 V Copper

Wire Branch Quick Connectors 30 pcs Lever Connector 1 Input and 4 Outputs for Conductor Cross-Sections 0.08 to 2.5 mm² 32 A 250 V Copper

Thirty branch quick connectors that distribute one supply wire to four wires. Each wire has its own lever and copper contact for a reliable connection. Full description
In stock
€26.16
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Wire Branch Quick Connectors 30 pcs Lever Connector 1 Input and 4 Outputs for Conductor Cross-Sections 0.08 to 2.5 mm² 32 A 250 V Copper For Electrical Installation

This value pack contains thirty lever-operated branch connectors that distribute one wire to four outputs. The supply wire is inserted from one side and the four outgoing wires from the opposite side, with each secured by its own lever. The connection can be undone at any time without damaging the wire. The connectors are rated for a current of 32 A and a voltage of 250 V. They are therefore suitable for lighting circuits, socket circuits and connecting small appliances. Installation requires no soldering, screwing or insulating tape.

The contact section is made of copper, which provides good conductivity and resists corrosion. A spring clip made of stainless steel grips the wire and retains its springiness even after being opened many times. The housing is made of flame-retardant plastic with increased heat resistance. The connector accepts wires with a cross-section of 0.08 to 2.5 mm², including fine-stranded wires and standard installation wires.

The branch design replaces bulkier terminal blocks and the practice of connecting several wires under one screw. Each wire has its own opening and lever, so you can disconnect one output without affecting the others. The connector is suitable for connecting four lights to one switch, distributing a neutral or protective conductor in several directions, or adding further appliances to an existing circuit. There is a small eyelet with an opening on the side of the housing.

  • Type – lever-operated branch connector with one input and four outputs
  • Rated current – 32 A
  • Rated voltage – 250 V
  • Conductor cross-section – 0.08 to 2.5 mm²
  • Dimensions – 29.5 x 23 x 13.3 mm
  • Contacts – copper
  • Spring – stainless steel
  • Body – flame-retardant plastic with increased heat resistance
  • Operation – a separate lever for each of the five wires
  • Package contents – 30 pcs branch lever connectors with 1 input and 4 outputs

Connecting the wires is simple. Strip the insulation from the end of the wire, lift the lever, insert the wire into the opening as far as it will go and lower the lever. Connect all four output wires in the same way. To change the connection, lift the lever again and pull out the wire. Always switch off the circuit breaker for the relevant circuit before starting work, and check that the entire stripped end of the wire is inserted inside the connector.

Thirty pieces in the pack are enough for rewiring an entire flat or for keeping as stock in a workshop. Distribute one supply wire in four directions without tools or an additional terminal block. The connectors with copper contacts provide a reliable tool-free connection and can be reused. The housing, measuring 29.5 x 23 x 13.3 mm, fits into a standard installation box or under a light fitting cover. This is a practical consumable for the workshop, home or service kit.

Price incl. VAT €26.16