Window and door seals

Draughts around windows and doors increase heat loss and also let noise, dust and insects into the home. Window and door seals close these gaps, mostly without drilling and without tools. They include self-adhesive rubber profiles I, E, P and D for gaps of different widths, brush seals for sliding windows and wardrobes, and door bottom seals.

Window and door seals

The most common type is self-adhesive EPDM rubber profiles, which compress when the window is closed and fill the gap. The flat I profile suits narrow gaps of about 1 to 1.5 mm, the E profile gaps of 2 to 3.5 mm, the P profile gaps of 3 to 5 mm, and the hollow D profile also larger and uneven gaps of 3.5 to 5.5 mm. The gap width can be measured with a piece of modelling clay wrapped in cling film and caught in the closed window.

For sliding windows, doors and wardrobes, there are brush seals with dense bristles that seal gaps of 3 to 5 mm without slowing the sliding movement. The gap under the door is closed by door bottom seals, either brush strips or flat strips of silicone or acrylic, fitted to the lower part of the door leaf.

For window and door seals to hold well, stick them onto a clean, dry and degreased surface, ideally at room temperature, and do not stretch them when fitting. After sealing, it is important to ventilate regularly so that moisture does not linger in the room. In rooms with a gas boiler, gas water heater or open fire, the sealing must not restrict the supply of air needed for combustion.