Home page Home page Home & Household Supplies Home electrical supplies Back boxes and blanking plates T-shaped Wire Tap Quick Connectors 10 pcs T1 No Stripping Required For 18 to 22 AWG Wires 25.2 x 6.5 mm For Cars and LED Lights
T-shaped Wire Tap Quick Connectors 10 pcs T1 No Stripping Required For 18 to 22 AWG Wires 25.2 x 6.5 mm For Cars and LED Lights

T-shaped Wire Tap Quick Connectors 10 pcs T1 No Stripping Required For 18 to 22 AWG Wires 25.2 x 6.5 mm For Cars and LED Lights

Ten T1 wire tap connectors for branching 18–22 AWG wires without stripping or soldering. Suitable for cars, LED strips, desk lamps, audio equipment and low-voltage wiring. Full description
In stock
€8.25
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
T-shaped Wire Tap Quick Connectors 10 pcs T1 No Stripping Required For 18 to 22 AWG Wires 25.2 x 6.5 mm For Cars and LED Lights

T-shaped wire tap quick connectors are used to connect a new wire to an existing cable without interrupting the original wiring. The T1 model is designed for wires rated at 18 to 22 AWG and works with both solid and stranded wires. There is no need to strip or solder the wires; the metal contact inside the connector cuts through the insulation when the cover is snapped shut. The connector has compact dimensions of 25.2 x 6.5 mm, so it fits even in tight spaces behind a dashboard or inside a light fitting. The pack of ten is enough for a typical installation in a car or for distributing power to several lights at once.

Installation takes just a few seconds. First, open the cover, place the through-wire in the top groove and insert the wire to be branched off into the side opening as far as it will go. Then press the cover shut with pliers until it clicks firmly into place. This presses the contact into both wires and completes the connection. The connector’s transparent body allows you to check visually that both wires have been inserted correctly. Plastic rings in the openings hold the cable in place; if the wire is slightly thicker, simply break off the ring or cut it off with scissors so the cable can pass through easily. The connector is rated for 220 V. Ten connectors can be used, for example, to connect daytime running lights, auxiliary lights and several LED strips in one project, with some left over.

  • Type – T-shaped wire tap quick connector, 1 wire to 1 branch
  • Model – T1
  • Wire gauge – 18 to 22 AWG
  • Wire type – solid and stranded wire
  • Dimensions – 25.2 x 6.5 mm
  • Voltage – 220 V
  • Installation – no stripping or soldering required; snap the cover shut with pliers
  • Design – transparent body with a black component
  • Package contents – 10 T1 wire tap connectors

The connectors are useful for installing home lighting, connecting auxiliary lights, car radios and speakers in cars, LED strips and low-voltage wiring. Always disconnect the power before installation and check that the cable gauge is within the connector’s range. Not all 18 AWG wires have the same outer insulation diameter, so allow for breaking off the plastic ring when using thicker cables.

T1 wire tap connectors offer a simple way to connect another device to existing wiring without cutting the cable. Installation without stripping saves time and avoids the need for wire strippers and a soldering iron. The transparent body makes it easier to check the connection, while the compact size allows use even in small spaces. The pack of ten is a practical choice for DIY enthusiasts and for modifications to a car’s electrical system. The pack contains 10 connectors, ready for immediate use.

Price incl. VAT €8.25