Home page Home page Hobbies & Garden Tools Drills & Accessories Drill Bits Pack of 20 Diamond Core Drill Bits 8 mm 6.35 mm Hex Shank Length 80 mm Black Dry Drilling of Holes in Tiles and Granite
Pack of 20 Diamond Core Drill Bits 8 mm 6.35 mm Hex Shank Length 80 mm Black Dry Drilling of Holes in Tiles and Granite

Pack of 20 Diamond Core Drill Bits 8 mm 6.35 mm Hex Shank Length 80 mm Black Dry Drilling of Holes in Tiles and Granite

Twenty 8 mm diameter core drill bits for anchors and larger wall plugs. The diamond tip drills dry through ceramic tiles porcelain tiles marble and hard granite. Full description
In stock
€62.40
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Pack of 20 Diamond Core Drill Bits 8 mm 6.35 mm Hex Shank Length 80 mm Black Dry Drilling of Holes in Tiles and Granite

Twenty diamond core drill bits with an 8 mm diameter provide a ready supply for drilling holes for larger wall plugs and anchors in ceramic floor tiles wall tiles and stone. An 8 mm hole is used for mirrors grab rails washbasin holders and cable passages. Each core drill bit has a 6.35 mm hex shank and fits a cordless drill as well as an impact driver. The brazed diamond tip removes material by abrasion, dry, so you can complete the installation even in a finished bathroom. The tool has an overall length of 80 mm and a working length of 42 mm.

The larger diameter removes more material, and the tip wears faster than those on smaller sizes. The pack of twenty therefore provides enough for a long series of installations without having to buy individual drill bits. The hollow design removes only a ring of material, leaving the drilled core inside the bit. This means the drill requires less force and the hole has a clean edge, even in hard granite. The 42 mm working length passes through the tile and adhesive layer in one go.

  • Number of pieces – 20 identical core drill bits
  • Diameter – 8 mm
  • Type – hollow diamond core drill bit with brazed diamond
  • Shank – 6.35 mm hex
  • Overall length – 80 mm
  • Working length – 42 mm
  • Material – steel body with diamond segment
  • Drilling method – dry, without water cooling
  • Suitable for – ceramic tiles, wall tiles, porcelain tiles, marble and granite
  • Colour – black
  • Pack contents – 20 diamond core drill bits with an 8 mm diameter

Before drilling, switch off the hammer action and apply only light pressure. Start the hole at an angle and, once the diamond has bitten, hold the core drill bit perpendicular to the surface. Every few seconds, pull the tool back slightly to clear the dust and cool the tip. On glazed surfaces, masking tape can help keep the tool in place. Keep the speed in the lower half of the range and let the diamond grit do the work. Extract the dust directly at the hole so it does not remain in the grout or silicone.

This supply of twenty core drill bits of the same size is intended for tilers, installation companies and DIY enthusiasts renovating several rooms at once. With one diameter, you can handle most anchors for heavier brackets without having to look for a replacement during the job. Along with 6 mm, the 8 mm diameter is one of the most common wall plug sizes in bathrooms and kitchens. Dry drilling saves time because there is no need for a container of water or the subsequent clean-up of a wet floor. The core drill bits fit the same holder, so replacing a blunt one takes only a moment. Twenty tools will see you through an entire renovation as well as a long run of customer jobs. Store them back in the box to protect the diamond coating from rubbing against other tools.

Price incl. VAT €62.40