Home page Home page Home & Household Supplies Home electrical supplies Back boxes and blanking plates Lever-operated wire branching connectors 30 pcs Quick connector 1 input and 5 outputs for conductor cross-section 0.08 to 2.5 mm² 32 A 250 V Copper
Lever-operated wire branching connectors 30 pcs Quick connector 1 input and 5 outputs for conductor cross-section 0.08 to 2.5 mm² 32 A 250 V Copper

Lever-operated wire branching connectors 30 pcs Quick connector 1 input and 5 outputs for conductor cross-section 0.08 to 2.5 mm² 32 A 250 V Copper

Thirty quick-connect branching connectors for splitting one supply into five wires. Individual lever for each opening and copper contacts with no screws. Full description
In stock
€36.20
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Lever-operated wire branching connectors 30 pcs Quick connector 1 input and 5 outputs for conductor cross-section 0.08 to 2.5 mm² 32 A 250 V Copper For electrical installation

This value pack contains thirty lever-operated branching connectors that split one wire into five outputs. The supply wire is inserted from one side and the five outgoing wires from the opposite side, with each one secured by its own lever. The connection can be disconnected again at any time without damaging the wire. The connectors are designed for a rated current of 32 A and a rated voltage of 250 V. They are therefore suitable for lighting circuits, socket circuits and connections for small appliances. Installation requires no soldering, screws or insulating tape.

The contact section is made of red copper, which provides good conductivity and resists corrosion. A spring clip made of stainless steel grips the wire and retains its elasticity even after being opened many times. The housing is made of heat-resistant, flame-retardant plastic. The connector accepts wires with a cross-section of 0.08 to 2.5 mm², including thin stranded wires and standard installation wires.

The branching design replaces bulkier terminal blocks and the practice of connecting several wires under one screw. Each wire has its own opening and lever, so you can disconnect one output without affecting the others. The connector is suitable for connecting several lights to one switch, distributing a neutral or protective conductor in up to five directions, or adding further appliances to an existing circuit. There is a small eyelet with an opening on the side of the housing.

  • Type – lever-operated branching connector with one input and five outputs
  • Rated current – 32 A
  • Rated voltage – 250 V
  • Conductor cross-section – 0.08 to 2.5 mm²
  • Dimensions – 29.5 x 28 x 13.3 mm
  • Contacts – red copper
  • Spring – stainless steel
  • Body – flame-retardant plastic with enhanced heat resistance
  • Operation – individual lever for each of the six wires
  • Package contents – 30 lever-operated branching connectors with 1 input and 5 outputs

Connecting the wires is simple. Strip the end of the wire, lift the lever, insert the wire into the opening as far as it will go, then lower the lever. Connect all five output wires in the same way. To change the connection, simply lift the lever again and pull out the wire. Before starting work, always switch off the circuit breaker for the relevant circuit and check that the entire stripped end of the wire is inside the connector.

The pack of thirty is enough for rewiring an entire flat or keeping as workshop stock. You can split one supply into up to five directions without tools or an additional terminal block. Connectors with red copper contacts provide a reliable tool-free connection and can be reused. The housing, measuring 29.5 x 28 x 13.3 mm, fits into a standard installation box or under a light fitting cover. A practical consumable for the workshop, home or service case.

Price incl. VAT €36.20