Home page Home page Home & Household Supplies Home electrical supplies Back boxes and blanking plates Lever-operated branching quick connectors 50 pcs Connector 1 input and 4 outputs for cables 0.08 to 2.5 mm² 32 A 250 V Copper contacts
Lever-operated branching quick connectors 50 pcs Connector 1 input and 4 outputs for cables 0.08 to 2.5 mm² 32 A 250 V Copper contacts

Lever-operated branching quick connectors 50 pcs Connector 1 input and 4 outputs for cables 0.08 to 2.5 mm² 32 A 250 V Copper contacts

Large pack of fifty branching quick connectors for distributing one conductor to four outputs without tools. Copper contacts and a lever for each conductor. Full description
In stock
€45.81
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Lever-operated branching quick connectors 50 pcs Connector 1 input and 4 outputs for cables 0.08 to 2.5 mm² 32 A 250 V Copper contacts For electricians

This large pack contains fifty lever-operated branching connectors for distributing one conductor to four outputs. The incoming conductor is inserted from one side and the four outgoing conductors from the opposite side, with each secured by its own lever. The connection can be disconnected at any time without damaging the conductor. The connectors are rated for a current of 32 A and a voltage of 250 V. They are therefore suitable for lighting circuits, socket circuits and connecting small appliances. Installation requires no soldering, screws or insulating tape.

The contacts inside the housing are made of red copper, which conducts electricity well and resists corrosion. The conductors are held in place by a spring clip made of stainless steel, which keeps the connection secure even after the levers have been opened repeatedly. The connector body is made of flame-retardant plastic with enhanced heat resistance. The openings accept conductors with a cross-sectional area of 0.08 to 2.5 mm², including solid conductors and flexible stranded wires.

The branching design replaces bulkier terminal blocks and the practice of connecting several conductors under one screw. Each conductor has its own opening and lever, so you can disconnect one output without affecting the others. The connector is suitable for connecting four lights to one switch, distributing a neutral or protective conductor in several directions, or adding more appliances to an existing circuit. There is a small eyelet with a hole on the side of the housing.

  • Type – lever-operated branching connector with one input and four outputs
  • Rated current – 32 A
  • Rated voltage – 250 V
  • Conductor cross-section – 0.08 to 2.5 mm²
  • Dimensions – 29.5 x 23 x 13.3 mm
  • Contacts – red copper
  • Spring – stainless steel
  • Body – flame-retardant plastic with enhanced heat resistance
  • Operation – separate lever for each of the five conductors
  • Package contents – 50 branching lever connectors with 1 input and 4 outputs

There are three steps to connecting the wires. Strip the insulation from the end of the conductor, lift the lever for the relevant opening and insert the conductor as far as it will go. Then lower the lever to secure the conductor. Connect all four output conductors in the same way. You can disconnect the connection at any time by lifting the lever and pulling out the conductor. Always switch off the power and check that no stripped ends protrude from the connector before carrying out any work on the electrical installation.

Fifty pieces in one pack are enough for a larger electrical installation renovation or to keep as long-term stock in a service vehicle. You can distribute one supply to four directions without tools or an additional terminal block. The red copper contacts ensure a reliable connection, while the levers allow it to be taken apart at any time. The body measures 29.5 x 23 x 13.3 mm, takes up little space in a junction box and keeps connections neat. This is a cost-effective solution for electricians, installation companies and building maintenance.

Price incl. VAT €45.81