Home page Home page PC & Laptop Accessories PC Components CPU coolers and fans Fan 60 x 60 x 10 mm 5 V 2-pin 20 dBA 3500 rpm Cable 100 mm Oil bearing Black For cooling CPU 3D printers and electronics
Fan 60 x 60 x 10 mm 5 V 2-pin 20 dBA 3500 rpm Cable 100 mm Oil bearing Black For cooling CPU 3D printers and electronics

Fan 60 x 60 x 10 mm 5 V 2-pin 20 dBA 3500 rpm Cable 100 mm Oil bearing Black For cooling CPU 3D printers and electronics

Flat 60 mm fan operating at 5 V, with a 100 mm cable and 2-pin connector, for quiet cooling of a processor, electronics, 3D printer or computer case. Full description
In stock
€8.69
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Fan 60 x 60 x 10 mm 5 V 2-pin 20 dBA 3500 rpm Cable 100 mm Oil bearing Black For cooling CPU 3D printers and electronics

The flat 60 x 60 x 10 mm fan has the largest blade area in this range of small 5 V fans and is suitable for situations where a greater volume of air needs to be moved at a low speed. It operates at 5 V and connects via a two-wire cable with a 2-pin connector. It can be used in a computer case, on a processor heatsink, in an electronics enclosure or with a 3D printer. The black plastic frame has four mounting holes in the corners, making it easy to screw the fan to a panel, grille or heatsink.

The blades rotate at 3500 rpm with a tolerance of 10%, and the fan delivers an airflow of 6 CFM. The lower speed contributes to quiet operation, with the noise level specified as 20 dBA. The current draw is 0.18 A, so the fan can be powered without issue by a standard 5 V output. The cable is 100 mm long and ends in a small connector that makes connection and replacement easier. The oil bearing ensures smooth operation, and the manufacturer specifies a service life of 20,000 hours.

  • Dimensions – 60 x 60 x 10 mm
  • Power supply – 5 V
  • Current – 0.18 A
  • Speed – 3500 rpm ± 10%
  • Airflow – 6 CFM
  • Noise level – 20 dBA
  • Bearing – oil
  • Service life – 20,000 h
  • Cable length – 100 mm
  • Connection – 2 wires and a 2-pin connector with a 2.5 mm pitch
  • Colour – black
  • Package contents – 1 60 x 60 x 10 mm fan with cable and connector

When installing the fan, orient it according to the required airflow direction; the intake and exhaust sides are easy to distinguish on the frame. Connect it to a 5 V supply and secure the cable so that it cannot get caught in the blades. Remove any settled dust from the blades and frame from time to time using a soft brush or compressed air to keep cooling effective and operation quiet. The fan can operate horizontally or vertically, so it can be fitted to the side wall of an enclosure, under a board or above a heatsink. In larger setups, several units can be used side by side to create a continuous airflow across the entire board. When replacing an older part, simply compare the frame dimensions, cable length and connector type.

The 60 mm fan is a versatile component for cooling computers, 3D printers, network devices and home electronics, and also works well as a replacement for a worn part. Quiet operation, low supply voltage and a simple two-wire connection make it easy to incorporate into a wide variety of projects. At just 10 mm thick, it also fits into shallow enclosures and behind panels where a thicker fan would not have enough room for installation.

Price incl. VAT €8.69