Home page Home page Hobbies & Garden Tools Drills & Accessories Drill Bits Diamond Drill Core Bit 10 mm Brazed Diamond Hex Shank 6.35 mm Length 80 mm Black Dry Drilling into Tiles and Stone
Diamond Drill Core Bit 10 mm Brazed Diamond Hex Shank 6.35 mm Length 80 mm Black Dry Drilling into Tiles and Stone

Diamond Drill Core Bit 10 mm Brazed Diamond Hex Shank 6.35 mm Length 80 mm Black Dry Drilling into Tiles and Stone

A 10 mm diameter hole for a wall plug or a hose to pass through. The diamond tip cuts through wall tiles porcelain tiles marble and granite without water or hammer action. Full description
In stock
€8.25
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Diamond Drill Core Bit 10 mm Brazed Diamond Hex Shank 6.35 mm Length 80 mm Black Dry Drilling into Tiles and Stone

The 10 mm diameter diamond drill core bit drills a clean hole in ceramic floor tiles, wall tiles and natural stone. The diamond grit is permanently brazed onto the tip and removes material dry, so there is no need for water cooling. The core bit has a 6.35 mm hex shank and fits securely in a cordless drill or impact driver. The 10 mm diameter suits standard wall plugs for bathroom and kitchen fittings and is also large enough for a thin hose to pass through. The overall length of 80 mm leaves plenty of room for the tile and the layer of adhesive beneath it.

The core bit has a hollow body, so the tool removes only a ring of material. The drilled core remains inside the bit, meaning the drill requires less force than with a solid drill bit, while the edge of the hole remains free of chips. A light-coloured scale on the black body helps you monitor the drilling depth in the tile. The working section is 42 mm long and can pass through even thick porcelain tiles in a single pass.

  • Diameter – 10 mm
  • Type – hollow diamond core drill bit with brazed diamond
  • Shank – 6.35 mm hex
  • Overall length – 80 mm
  • Working section – 42 mm
  • Material – steel body with diamond segment
  • Drilling method – dry, without water cooling
  • Suitable for – ceramic floor tiles, wall tiles, porcelain tiles, marble and granite
  • Colour – black
  • Package contents – 1 diamond drill core bit with a diameter of 10 mm

Drill without hammer action and apply only light pressure. Start the hole at an angle and, once the diamond has bitten into the surface, hold the core bit perpendicular to it. Every few seconds, withdraw the tool slightly to clear dust from the hole and allow the tip to cool. A piece of masking tape can help on smooth glazed surfaces by preventing the bit from slipping. After use, tap out the drilled core and store the bit dry, separately from your other tools. Place a container beneath the drilling point or hold a vacuum cleaner nozzle close to it to stop dust spreading throughout the room. Keep the speed in the lower half of the drill's range, as diamond works by abrasion and higher speeds will not improve performance.

The core bit is suitable for installing shelves, mirrors, tap fittings and shower rails, as well as routing cables through tiles. The 10 mm diameter fits the wall plugs most commonly used for medium-weight fittings. Dry drilling means you only need a drill and a vacuum cleaner, and afterwards there will be dust but no wet floor. The hex shank holds the tool securely even at higher torque, and changing it takes just a few seconds. The steel body with a diamond segment withstands repeated use on hard ceramic. Regularly cleaning dust from the tip keeps the diamond layer sharp for many more holes, and the core bit can be used on the tiles throughout your home.

Price incl. VAT €8.25