Home page Home page Hobbies & Garden Tools Drills & Accessories Drill Bits Diamond Core Drill Bit 5 mm Hexagonal Shank 6.35 mm Length 68 mm Working Length 35 mm Black Dry Drilling into Tiles
Diamond Core Drill Bit 5 mm Hexagonal Shank 6.35 mm Length 68 mm Working Length 35 mm Black Dry Drilling into Tiles

Diamond Core Drill Bit 5 mm Hexagonal Shank 6.35 mm Length 68 mm Working Length 35 mm Black Dry Drilling into Tiles

The smallest diameter in the set for small wall plugs and screws. The brazed diamond tip cuts through glaze sintered tiles and stone dry and without pre-drilling. Full description
In stock
€7.38
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Diamond Core Drill Bit 5 mm Hexagonal Shank 6.35 mm Length 68 mm Working Length 35 mm Black Dry Drilling into Tiles

This 5 mm diameter diamond core drill bit is designed for small holes in ceramic floor and wall tiles and natural stone. It is suitable for wall plugs for small brackets hooks and trim where a larger hole would unnecessarily damage the surface. The diamond grit is brazed onto the tip and the bit drills dry so there is no need for a container of water nearby. The shank is hexagonal 6.35 mm and fits both a cordless drill and an impact driver. The short body, at 68 mm long, is easy to guide even in tight spaces near a room corner.

The bit is hollow and removes only a thin ring of material. This means less force is needed for drilling and the glaze does not chip around the edge of the hole. The working length is 35 mm, enough for the tile and the adhesive beneath it. A clear scale on the body shows how deep you have drilled.

  • Diameter – 5 mm
  • Type – hollow core drill bit with brazed diamond
  • Shank – hexagonal 6.35 mm
  • Overall length – 68 mm
  • Working length – 35 mm
  • Material – steel body with diamond segment
  • Drilling method – dry, without water cooling
  • Suitable for – ceramic floor tiles, wall tiles, sintered tiles, marble and granite
  • Colour – black
  • Package contents – 1 diamond core drill bit, 5 mm diameter

The small diameter calls for a steady hand. Start at a slight angle so the tip bites into the glaze, then straighten the bit. Apply only light pressure and let the rotation do the work, not the force of your arm. Occasionally withdraw the bit from the hole to clear the dust and cool the diamond. Once drilling is complete, tap the core out of the bit and store it dry, separately from your other tools. For thin tiles, support the board with a piece of wood to prevent the edge of the hole from breaking out as the bit passes through. Keep the speed low and give the diamond time to cut its way through the material without unnecessary pressure.

Use the 5 mm hole for fixing trim hooks toothbrush holders and small screws in bathroom furniture. It is equally useful for drilling into floor tiles when the hole must be positioned precisely away from the grout line. As drilling is done without hammer action, there is no risk of the tile breaking out at the grout line. Dry drilling is quick and leaves only fine dust to clean up. The hexagonal shank fits in a chuck or a magnetic bit holder, and the tool can be changed in moments. This bit complements the larger diameters in the same range and takes up very little space in the workshop. Its slim body also fits between the pipes under a washbasin, where bulky tools are awkward to use. With regular cleaning of the tip, the diamond layer stays sharp for dozens of holes in tiles.

Price incl. VAT €7.38