Home page Home page Auto & Moto Car Spare Parts Car body parts Car B-Pillar Seal 2 Pieces Length 80 cm Rubber Strip with Steel Reinforcement Push-On Fit Black Noise Reduction and Water Protection
Car B-Pillar Seal 2 Pieces Length 80 cm Rubber Strip with Steel Reinforcement Push-On Fit Black Noise Reduction and Water Protection

Car B-Pillar Seal 2 Pieces Length 80 cm Rubber Strip with Steel Reinforcement Push-On Fit Black Noise Reduction and Water Protection

Two 80 cm push-on sealing strips for the B-pillar reduce road noise and prevent water and dust from getting between the doors and the car body. Full description
In stock
€19.61
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Car B-Pillar Seal 2 Pieces Length 80 cm Rubber Strip with Steel Reinforcement Push-On Fit Black Noise Reduction and Water Protection

The car B-pillar seal is a practical accessory for anyone bothered by wind noise while driving or looking to seal the gap between the front and rear doors more effectively. The pack contains 2 strips, each 80 cm long, enough for both B-pillars of the car. The strip simply pushes onto the edge of the pillar and is held in place by its U-shaped profile with built-in steel reinforcement. When the door is closed, the soft rubber section presses against its edge and fills the gap through which noise, water and dust would otherwise get in. You can fit it yourself without drilling or adhesive.

The strip consists of two parts. The U-shaped clamping section contains metal reinforcement, which grips the edge of the pillar when pushed on and keeps the strip in place even when the doors are opened frequently. The upper sealing section is made from flexible foam rubber, which compresses when the door is closed and returns to its original shape afterwards. This allows the strip to remain flexible and fill uneven gaps too. Once fitted, the 80 cm length can easily be trimmed with scissors to match the height of your car's pillar.

  • Type – car B-pillar sealing strip
  • Length – 80 cm per strip
  • Number of strips – 2, one for each side of the car
  • Material – foam rubber with steel reinforcement
  • Profile – U-shaped clamping profile with rubber sealing section
  • Fitting – pushes onto the edge of the pillar, no adhesive or drilling required
  • Length adjustment – excess can be trimmed with scissors
  • Colour – black
  • Function – noise reduction and protection against water and dust
  • Package contents – 2 sealing strips for the B-pillar, each 80 cm long

Before fitting, clean dust and grease from the edge of the B-pillar. Fit the strip with the soft rubber section facing outwards towards the door, then press it along its entire length by hand until the clamping profile is firmly in place. Next, check the length against the pillar and trim off any excess. Finally, press the entire strip firmly into place once more. For routine car washing, simply wipe the strip with a damp cloth.

A set of two B-pillar sealing strips is a simple way to improve the door seal without visiting a garage. The clamping profile with steel reinforcement holds the strip firmly on the edge of the pillar, while the rubber section fills the gap between the doors. The result is a quieter drive, even at higher speeds, and less water and dust getting into the area around the doors. Fitting takes just a few minutes, requires no special tools, and the length can easily be adjusted to suit your car. Thanks to the push-on fitting, the strip can also be removed and refitted if needed. The strips are black, so they blend discreetly with the pillar and suit most interiors.

Price incl. VAT €19.61