LUNZO s.r.o. (Czechia) · info@lunzo.ie · +420 603 337 330 · Mon–Sun 8:00–17:00 Irish time · Contact Us

Home page Home page Auto & Moto Car Electronics Power Inverters Automatic Source Switch ATS 2P 100 A 230 V Switching in 50 ms Manual and Automatic Mode for DIN Rail Black for Generator and Backup
Automatic Source Switch ATS 2P 100 A 230 V Switching in 50 ms Manual and Automatic Mode for DIN Rail Black for Generator and Backup

Automatic Source Switch ATS 2P 100 A 230 V Switching in 50 ms Manual and Automatic Mode for DIN Rail Black for Generator and Backup

Automatically switches power from the mains to the generator during a power outage. Two poles, current 100 A and switching in 50 ms with manual and automatic mode selection. Full description
In stock
€73.76
Safe shopping Safe shopping
Overview
Automatic Source Switch ATS 2P 100 A 230 V Switching in 50 ms Manual and Automatic Mode for DIN Rail Black for Generator and Backup

The automatic source switch monitors the power supply and switches the load to the backup source during a power outage. Switching takes less than 50 ms, so connected devices experience virtually no interruption. The device is two-pole with a rated current of 100 A and operates at a voltage of 230 V. Source A is intended for the mains, while source B is for the generator or other backup power supply. The switch can be toggled to manual or automatic mode using a sliding control. The body is black with a red toggle lever and dimensions of 17 x 15 x 11 cm.

Features:

  • Rated current 100 A — capacity for residential and operational distribution with higher consumption.
  • Two poles — 2P design for phase and neutral conductor.
  • Voltage 230 V — connection to a standard single-phase network.
  • Switching time of 50 ms — minimal interruption of supply.
  • Source A for mains — primary power supply from the distribution network.
  • Source B for generator — backup power during an outage.
  • Manual and automatic mode — selection via a sliding switch.
  • Toggle lever — manual switching between positions A and B.
  • Indicators A and B — indication of the active source.
  • Signal terminal block — NC, C, and NO contacts for both sources.
  • Mounting on DIN rail — installation into a standard distribution board.
  • Dimensions 17 x 15 x 11 cm — compact design.
  • Black colour — body with a red lever and transparent terminal covers.

Contents of the package:

  • 1x automatic source switch

The switch is useful in a family home, at a cottage, in a workshop, in a server room, and in a business where a power outage means a problem. Switching time of 50 ms is so short that most devices do not even register the outage. Manual mode allows for hard switching of the source during inspection or maintenance of the distribution. Indicators A and B show at a glance which source is currently powering the load. DIN rail mounting allows for installation into an existing distribution board without modifications to the enclosure.

Price incl. VAT €73.76