Home page Home page Hobbies & Garden Tools Soldering Irons & Accessories Soldering Kit for a Clap-Activated Sound Switch with Microphone and Four 9013 Transistors Bistable Output with LED 5 V Power Supply
Soldering Kit for a Clap-Activated Sound Switch with Microphone and Four 9013 Transistors Bistable Output with LED 5 V Power Supply

Soldering Kit for a Clap-Activated Sound Switch with Microphone and Four 9013 Transistors Bistable Output with LED 5 V Power Supply

Soldering kit for a switch that turns on when you clap and turns off when you clap again. Flip-flop circuit with microphone and LED output status indicator, 5 V power supply. Full description
In stock
€4.76
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Soldering Kit for a Clap-Activated Sound Switch with Microphone and Four 9013 Transistors Bistable Output with LED 5 V Power Supply

This sound switch kit is a soldering set that you assemble into a circuit that responds to clapping. The sound is picked up by an electret microphone, the signal is amplified by a pair of transistors, and two further transistors form a bistable flip-flop that remembers its state. The first clap switches the output on, and the next switches it off again. The entire circuit is built using four 9013 transistors and is powered by 5 V, according to the circuit diagram. The kit is supplied as loose components for you to fit onto the printed circuit board yourself.

The microphone is in the upper left-hand part of the board, with a 47 µF electrolytic capacitor next to it and a green screw terminal block in the centre for connecting the power supply. The bottom row contains four transistors, 104 ceramic capacitors, a 0.1 µF electrolytic capacitor and two 1N4148 diodes, which switch the flip-flop. On the right-hand edge is a red LED that shows whether the output is switched on, together with three output solder pads for connecting another circuit. According to the circuit diagram, the sensitivity of the microphone amplifier is determined by resistor R2, so you can experiment with how its value affects the response to sound. The output is brought out to a pin header, allowing you to connect another module or your own circuit, for example.

  • Type – soldering kit for a clap-activated sound switch
  • Function – the first clap switches the output on and the next switches it off
  • Circuit – microphone amplifier and bistable flip-flop
  • Transistors – 4 x 9013
  • Sound sensor – electret microphone
  • Indicator – red LED output status indicator
  • Power supply – 5 V via screw terminal block
  • Format – loose components for soldering and assembly
  • Package contents – printed circuit board and component set (electret microphone, 4 x 9013 transistors, 2 x 1N4148 diodes, LED, electrolytic and ceramic capacitors, resistors, screw terminal block, pin header)

When assembling the kit, start with the resistors and diodes, then fit the ceramic capacitors, transistors, electrolytic capacitors, terminal block and finally the microphone and LED. Insert the transistors according to the outline on the board, and observe the polarity of the electrolytic capacitors, diodes and LED. After soldering, check the joints, trim the excess leads, remove any flux residue and only then connect the power supply, observing the correct polarity as marked on the board.

Clap-operated switches are popular kits because the result is fun and immediately visible. With a single circuit, you can learn how a microphone signal amplifier works and how a flip-flop remembers whether it is switched on or off. The kit is suitable for soldering beginners, children under adult supervision, students and electronics clubs. The finished switch can be used as a demonstration project or as a starting point for further experiments with sound control. Thanks to the clearly labelled board, assembly can be completed in an afternoon.

Price incl. VAT €4.76