Home page Home page Auto & Moto Car Spare Parts Car body parts Self-Adhesive Car Seal Profile B Length 5 m EPDM Rubber Black Noise, Water and Dust Seal for Bonnet or Boot Lid
Self-Adhesive Car Seal Profile B Length 5 m EPDM Rubber Black Noise, Water and Dust Seal for Bonnet or Boot Lid

Self-Adhesive Car Seal Profile B Length 5 m EPDM Rubber Black Noise, Water and Dust Seal for Bonnet or Boot Lid

5 m roll of rubber seal with profile B and adhesive tape for the bonnet or boot lid. Dampens noise, prevents water and dust from entering the engine and boot. Full description
In stock
€13.49
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Self-Adhesive Car Seal Profile B Length 5 m EPDM Rubber Black Noise, Water and Dust Seal for Bonnet or Boot Lid

The self-adhesive seal with a B-shaped profile is a simple way to further seal the doors, bonnet or boot of your car. The strip is made from EPDM rubber, which remains flexible and withstands rain, sun, and temperature fluctuations well. The hollow profile with two chambers compresses when the doors are closed, filling the gap between the bodywork and the doors. As a result, less noise from the road, less wind noise, and less dust and water enter the cabin. The roll, measuring 5 m, is intended by the seller for the circumference of the engine bonnet or boot lid.

On the back of the strip, there is double-sided adhesive tape protected by a red film, allowing you to install it yourself without tools or drilling. The seal adheres to the door frame or the edge of the opening in the bodywork and complements the original car seal. The strip can be easily cut to the required length with scissors or a knife. The five-metre roll is particularly suitable for large opening parts of the bodywork. When applied around the bonnet, it helps limit the ingress of dust and water into the engine compartment, while on the boot lid, it prevents water from seeping in and dirt from settling in the boot. The strip can also be used on doors if you need to seal a longer section.

  • Type – self-adhesive sealing strip for cars
  • Profile – shape B with two hollow chambers
  • Material – EPDM rubber
  • Length – 5 m
  • Colour – black
  • Attachment – double-sided adhesive tape with protective film
  • Usage – for the engine bonnet or boot lid
  • Function – noise dampening and protection against water and dust
  • Package Contents – 1 roll of sealing strip measuring 5 m

Before applying, thoroughly clean and degrease the area where the strip will be attached, and allow it to dry. Start by peeling off a piece of the protective film, place the strip on the frame, and gradually press it down while pulling off the film further. After applying, do not pull the strip and avoid washing the car for at least three days to allow the adhesive to set properly. During the first 24 hours, try not to open the doors unnecessarily. The doors may close tightly for the first two to three days after installation until the seal settles. Therefore, always check that the doors are properly closed in the first few days.

The universal seal with a B profile helps enhance comfort during daily driving. The 5 m roll is sufficient for the circumference of the bonnet or boot lid and seals a large part of the bodywork in one piece. The flexible EPDM rubber adapts to the shape of the gap when the doors are closed, limiting the ingress of noise, water, and dust into the vehicle. Installation is quick and does not require any modifications to the bodywork. It is a simple addition that will improve the sealing and quieten the interior of your car.

Price incl. VAT €13.49