Home page Home page Auto & Moto Car Spare Parts Car body parts Self-Adhesive Car Door Seal Profile B Length 4 m EPDM Rubber Black Sealing Strip Against Noise Water and Dust for One Car Door
Self-Adhesive Car Door Seal Profile B Length 4 m EPDM Rubber Black Sealing Strip Against Noise Water and Dust for One Car Door

Self-Adhesive Car Door Seal Profile B Length 4 m EPDM Rubber Black Sealing Strip Against Noise Water and Dust for One Car Door

A 4 m roll of rubber seal with profile B and adhesive tape is sufficient for the perimeter of one car door. It reduces noise in the cabin and stops draughts, water, and dust. Full description
In stock
€13.49
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Self-Adhesive Car Door Seal Profile B Length 4 m EPDM Rubber Black Sealing Strip Against Noise Water and Dust for One Car Door

The self-adhesive seal with a B-shaped profile is a simple way to additionally seal the doors, bonnet, or boot of a car. The strip is made from EPDM rubber, which remains flexible and withstands rain, sun, and temperature fluctuations well. The hollow profile with two chambers compresses when the doors are closed, filling the gap between the body and the doors. As a result, less noise from the road, less wind noise, and less dust and water enter the cabin. A roll of 4 m is sufficient for the perimeter of one door, allowing you to seal the entire door frame with one roll.

On the back of the strip is double-sided adhesive tape protected by a red film, so you can install it yourself without tools or drilling. The seal adheres to the door frame or the edge of the opening in the body and complements the original car seal. The strip can be easily trimmed to the required length with scissors or a knife. The four-metre roll is suitable if you are bothered by noise or draughts from specific doors, typically the driver's side. You can apply the strip around the entire perimeter of the door frame in one continuous piece without unnecessary joints, which helps ensure the doors close evenly. Any leftover piece can be used for shorter sections elsewhere on the body.

  • Type – self-adhesive sealing strip for cars
  • Profile – shape B with two hollow chambers
  • Material – EPDM rubber
  • Length – 4 m
  • Colour – black
  • Attachment – double-sided adhesive tape with protective film
  • Usage – for the perimeter of one door
  • Function – noise dampening and protection against water and dust
  • Contents – 1 roll of sealing strip measuring 4 m

Before applying, thoroughly clean and degrease the area where the strip will be attached, and allow it to dry. Start by peeling off a piece of the protective film, position the strip on the frame, and gradually press it down while pulling off the film further. After applying, do not pull on the strip, and avoid washing the car for at least three days to allow the adhesive to set properly. During the first 24 hours, try not to open the doors unnecessarily. The doors may close stiffly for the first two to three days after installation until the seal settles. Therefore, always check that the doors are properly closed in the first few days.

This universal seal with profile B helps enhance comfort during everyday driving. A roll of 4 m is a sensible choice for sealing one door or several shorter areas on the vehicle. The flexible EPDM rubber adapts to the shape of the gap when the doors are closed, limiting the ingress of noise, water, and dust into the vehicle. Installation is quick and does not require any modifications to the bodywork. It is a simple accessory that improves the sealing and quietens the interior of your car.

Price incl. VAT €13.49