Home page Home page Home & Household Supplies Home electrical supplies Back boxes and blanking plates Lever Splitter Connectors 10 pcs 1 Input and 2 Outputs for Wires 0.08 to 2.5 mm² 32 A 250 V Copper Contacts No Screws
Lever Splitter Connectors 10 pcs 1 Input and 2 Outputs for Wires 0.08 to 2.5 mm² 32 A 250 V Copper Contacts No Screws

Lever Splitter Connectors 10 pcs 1 Input and 2 Outputs for Wires 0.08 to 2.5 mm² 32 A 250 V Copper Contacts No Screws

Lever connectors for splitting one wire into two without soldering. Copper contacts and stainless steel spring for home electrical installations. Full description
In stock
€10.87
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Lever Splitter Connectors 10 pcs 1 Input and 2 Outputs for Wires 0.08 to 2.5 mm² 32 A 250 V Copper Contacts No Screws

The package contains ten lever splitter connectors that divide one input wire into two outputs. The input wire is inserted from one side and the two output wires from the opposite side, each held by its own lever. The connector is rated for a current of 32 A and a voltage of 250 V. This makes it suitable for connecting two light fixtures to one supply, splitting a wire in a junction box, or connecting an additional appliance. All without soldering, screwing, or using insulating tape.

The contacts are made of red copper with good conductivity and corrosion resistance. The wires are pressed by a flexible stainless steel clip, which holds the connection firmly even after repeated opening of the levers. The body of the connector is made of flame-retardant plastic with increased thermal resistance. The connector accepts wires with a cross-section of 0.08 to 2.5 mm² and its dimensions are 29.5 x 13 x 13.3 mm.

The splitter design saves space and time wherever it would otherwise be necessary to connect three wires together under one terminal. Each wire has its own separate hole and lever, allowing you to disconnect one output at any time without releasing the others. The connector works with solid wires as well as flexible strands, as the flexible clip adapts to their shape. The connection does not require any additional insulation with tape, and the entire wiring remains neat and well-organised.

  • Type – lever splitter connector 1 input and 2 outputs
  • Rated current – 32 A
  • Rated voltage – 250 V
  • Wire cross-section – 0.08 to 2.5 mm²
  • Dimensions – 29.5 x 13 x 13.3 mm
  • Contacts – red copper
  • Spring – stainless steel
  • Body – flame-retardant plastic
  • Control – three levers, one for each wire
  • Contents – 10 pcs of lever splitter connectors

The connection is made in three steps. Remove the insulation from the end of the wire, lift the lever of the corresponding hole, and insert the wire until it stops. Then lower the lever, and the wire is secured. Connect both output wires on the other side in the same way. The connection can be disconnected at any time by lifting the lever and pulling out the wire. Always turn off the power before working on electrical installations and ensure that the stripped ends do not protrude from the connector.

The set of ten splitter connectors is a practical helper for modifying lighting, wiring sockets, and small repairs at home. One supply can be split into two directions without a terminal block and without screwing. The compact body fits into a standard junction box, and the connections remain clear. The grey casing with orange levers is easily visible among other wires. It is a quick and tidy solution for anyone who needs to reliably split a wire without complicated tools.

Price incl. VAT €10.87