Home page Home page Hobbies & Garden Tools Soldering Irons & Accessories Frequency Counter Kit for Soldering 1 Hz to 50 MHz with Crystal Measurement Five-Digit LED Display PIC Microcontroller Red Board
Frequency Counter Kit for Soldering 1 Hz to 50 MHz with Crystal Measurement Five-Digit LED Display PIC Microcontroller Red Board

Frequency Counter Kit for Soldering 1 Hz to 50 MHz with Crystal Measurement Five-Digit LED Display PIC Microcontroller Red Board

Soldering kit for frequency meter with automatic range selection and crystal oscillator testing. Powered by USB 5 V or 9 V battery for workshop and education. Full description
In stock
€11.31
Price incl. VATImport charges will apply
Safe shopping Safe shopping
Overview
Frequency Counter Kit for Soldering 1 Hz to 50 MHz with Crystal Measurement Five-Digit LED Display PIC Microcontroller Red Board

The frequency counter kit is a soldering set from which you can assemble a useful measuring instrument for your electronics workshop. The counter measures frequencies in the range of 1 Hz to 50 MHz and displays the result on a five-digit seven-segment LED display. Control is handled by a PIC microcontroller, and the range switches automatically without the need for manual adjustment. In addition to measuring signals, the counter can also measure the frequency of most commonly used crystals. All components are standard leaded types, and the circuit is simple, making it suitable for less experienced electronics enthusiasts.

Measurement has a resolution of five significant digits, for example, 0.0050 kHz, 4.5765 MHz, or 11.059 MHz. The counter offers programmable frequency addition and subtraction, which is useful for measuring receivers and transmitters with intermediate frequencies. There is also a power-saving mode that turns off the display if the frequency does not change significantly within 15 seconds. Crystals can be measured in the range of 4 to 20 MHz; a 32.768 kHz crystal cannot be measured, and for a 48 MHz crystal operating on the third harmonic, the fundamental frequency of 16 MHz will be displayed.

  • Type – frequency counter kit for soldering
  • Measuring Range – 1 Hz to 50 MHz
  • Crystal Measurement – 4 to 20 MHz
  • Display – five-digit seven-segment LED display
  • Control Circuit – PIC microcontroller
  • Range Selection – automatic
  • Function – programmable frequency addition and subtraction and power-saving mode
  • Power Supply – USB 5 V or 5 to 9 V DC or 9 V battery
  • Components – leaded for mounting into holes
  • Board Size – 80 x 53 mm
  • Package Contents – red printed circuit board and a set of components for soldering including microcontroller, LED display, crystal, and trimmer capacitor

The kit is supplied as loose components that need to be soldered and assembled. Resistors have no polarity, but their values must be monitored. For LEDs, the longer lead is positive, and for electrolytic capacitors, it is the same. Integrated circuits should be mounted so that the notch on the package matches the notch on the board print, and transistors according to the print. After soldering, the counter must be calibrated: apply a signal from a standard source to the input and adjust with the yellow trimmer capacitor so that the displayed value corresponds to the actual frequency. Without a generator, you can also calibrate using an accurate crystal. Power can be supplied via a USB cable with a 3.5 mm connector or a voltage of 5 to 9 V directly to the solder pads + and - while ensuring correct polarity.

The completed counter on a board measuring 80 x 53 mm is useful for reviving oscillators, checking crystals, and working with radio receivers. Building it teaches working with microcontrollers, displays, and input circuits of measuring instruments. The kit is suitable for amateur radio operators, electronics clubs, technical education, and as a gift for DIY enthusiasts.

Price incl. VAT €11.31