LUNZO s.r.o. (Czechia) · info@lunzo.ie · +420 603 337 330 · Mon–Sun 8:00–17:00 Irish time · Contact Us

Home page Home page Hobbies & Garden Measuring Instruments Protractors Digital Protractor with Laser and Magnets on Four Sides Measuring 62 x 60 x 33 mm with 360° Measurement and USB-C Charging in Green
Digital Protractor with Laser and Magnets on Four Sides Measuring 62 x 60 x 33 mm with 360° Measurement and USB-C Charging in Green

Digital Protractor with Laser and Magnets on Four Sides Measuring 62 x 60 x 33 mm with 360° Measurement and USB-C Charging in Green

The laser line projects the angle onto the wall, and the magnets hold the body onto the disc and vertical profile. The display shows degrees or percentages, and the digits automatically rotate. Full description
In stock
€60.66
Safe shopping Safe shopping
Overview
Digital Protractor with Laser and Magnets on Four Sides Measuring 62 x 60 x 33 mm with 360° Measurement and USB-C Charging in Green

The inclinometer in a solid prism made of aluminium alloy measures angles across a full range of 360°, allowing it to be positioned at any angle while keeping the reading legible. A red laser line emanates from the front face, projecting the measured slope onto the floor, wall, or workpiece, facilitating the transfer of angles over greater distances where a ruler would not reach. Magnets are located on all four sides of the body, allowing the device to hold onto the saw disc, vertical profile, or ceiling bracket without the need for holding or clamping. The body measures 62 x 60 x 33 mm and is operated with three buttons, where the red button powers on the device and laser, while the other two are used to hold the value and reset to zero. The display with green backlighting shows not only the numerical value but also the level and hold symbols, as well as the battery status of the built-in rechargeable battery.

  • Laser line from the front face – the beam marks the measured slope directly on the surface, allowing the angle to be transferred to the wall or beam without a ruler and without marking with a pencil.
  • Magnets on four sides – the device can be attached from the side, bottom, or top, enabling measurements on vertical profiles, saw discs, and the edge of steel constructions.
  • Measurement across the full range of 360° – the protractor works in any position and can handle both slight floor slopes and inverted placements overhead.
  • Angle conversion to slope – the value can be switched between degrees and percentage slope, which is useful for checking the gradient of pipes, ramps, or guttering.
  • Two methods of angle measurement – in addition to the absolute value relative to the horizontal plane, the device also measures the angle relative to the surface on which zero was set, allowing for comparison of two adjacent parts.
  • Digit rotation on the display – the display automatically flips according to the position of the body, ensuring that the value is read correctly even when the device is upside down.
  • Locking the measured value – the hold button retains the number on the display, allowing the device to be removed from an inaccessible location and the value noted down at a table.
  • Automatic shutdown – if the device is not in use, it will turn off after a while, preventing unnecessary battery drain during breaks in work.
  • Charging via USB-C connector – the built-in battery is recharged with a standard phone cable, eliminating the need to purchase disposable batteries.

Contents of the package:

  • 1x digital protractor

The laser protractor is suitable for workshops, construction sites, car repairs, and installations where machines are adjusted, the slope of structures is checked, or angled parts are measured. Before measuring, it is advisable to place the device on a flat surface and calibrate to zero, as all subsequent values will derive from this. The magnetic surfaces should be wiped clean of sawdust and metal shavings, as even small debris can lift the body and shift the measured angle. The laser beam should not be directed into the eyes, so the device should be positioned so that the line points to the work surface and not into areas where people are present. After use, the protractor should be wiped down, recharged, and stored away from moisture to ensure it is ready for the next measurement.

Price incl. VAT €60.66